St Peter's church, Terwick
St Peter's church, Terwick
The service on Christmas Day went very well and the heating was much admired and enjoyed! When I turned on the heaters at about 9.10am the temperature in the church was 10 degrees (much warmer than normal, of course) and when the service finished it was 15.5 degrees.
Who said it doesn't warm the building as well?!!!
On a normal December day, of course, it would not have been quite so good I am sure. Anyway, thank you for enabling us to have a warm, worry-free day; no descending the boiler room steps and dangling down a sump to change the water level in the boiler room. What a joy!
Now we just need the electrician to come back and finish off and then we can consider the decommissioning of the boiler room and the removal of the oil tank and then the whole job will be done. Yippee!
The service on Christmas Day went very well and the heating was much admired and enjoyed! When I turned on the heaters at about 9.10am the temperature in the church was 10 degrees (much warmer than normal, of course) and when the service finished it was 15.5 degrees.
Who said it doesn't warm the building as well?!!!
On a normal December day, of course, it would not have been quite so good I am sure. Anyway, thank you for enabling us to have a warm, worry-free day; no descending the boiler room steps and dangling down a sump to change the water level in the boiler room. What a joy!
Now we just need the electrician to come back and finish off and then we can consider the decommissioning of the boiler room and the removal of the oil tank and then the whole job will be done. Yippee!


Lady Nixon, Churchwarden
Lady Nixon, Churchwarden
Safe heating within the confined space of a church pew.
The panel heaters can be fitted as shown here or mounted between the seat of an open pew and the floor.
The heaters provide a gentle warmth that allows you to concentrate on the service without the discomfort of cold ankles.


The hot glass surface of our heaters is covered with two layers of strong polyester mesh, allowing the infrared energy to pass through whilst preventing contact with the glass. This results in a heating surface that is cool to the touch whilst providing the heating effect that is expected.